The preparation of the most important tools, as well as materials for installing a film underfloor heating, is key. If you do not, you can expect any problems.
Preparation of materials and tools for mounting a film floor
In order for the installation of the film floor to go as soon as possible and without errors, it is worth preparing the thermal film and all the additional elements.
Do not forget about the thermostat, as well as any other heat-reflecting material. It will also require a plastic film, adhesive tape, a knife and scissors, a stapler and a screwdriver. You can also add pliers to this list.
Instructions for installing a film underfloor heating under linoleum
To get started, prepare the base and level the plane. To do this, you can recommend a screed with a special solution. They also lay waterproofing on it, and then sheets of glued plywood. Laying plywood on the floor is staggered.
Then you need to take measurements and make a plan on which places with thermal film will be indicated. When everything is ready, you need to choose a place on the wall, where the thermostat will be installed. This place should be accessible, and the distance to the source should be kept to a minimum. On sale you can find rolls completely ready for installation. In order to simplify the task, you need to fix the thermal insulator using double-sided tape. Alternatively, you can try staples and a stapler. These tools will help to do without more expensive devices, which not everyone has. It is important to note that all joints that are located between the strips must be sealed with tape. The entire surface must be perfectly tight.
Now it remains to put the thermal film. Remember the labeling and the fact that the underside of the thermal film should be turned to the heat-reflecting film. By the way, if we are talking about low furniture, then under it they do not do any heating at all. This can cause irreparable harm to the furniture, because of which it will quickly become unusable.
The underfloor heating of the infrared film laying under linoleum is such that it is time for isolation and connection. First you need to remember the requirements of the PUE, as well as all the recommendations of the manufacturer of the material. You can learn about them from the instructions. It is also necessary to use all connectors without fail, as well as special insulation materials that come with the kit. Only with their availability can you be sure that the design will last a long time and there will be no problem with it.
How to put a film underfloor heating under linoleum? So, all the cut points of a wide copper busbar are insulated with bitumen insulation. Where the places for connecting wires to the bus are located, contact clamps are installed. They are squeezed as tightly as possible with pliers.
Each of the strips of special thermal film should be fixed with adhesive tape. If this is not done, then you can expect any unpleasant consequences. In case everything is normal, then you can connect the wires for power. In order to increase the service life of the entire structure, it is recommended to tin all bare ends. This is an extremely dangerous job, because an inexperienced master can be shocked. However, without this, contact at the junctions may be too weak.
Now they install the notorious temperature controller on the wall, and also connect the system to the mains. On this, the installation is over and you can finally breathe a sigh of relief.
Possible errors and their elimination
When installing a film underfloor heating, installation under the linoleum of which can cause difficulties, errors may occur.
- During operation, errors inevitably occur. This is a completely normal and natural process. In order to avoid them, you need to understand in advance how much work. The most common mistake is a banal lack of time. In order to prevent such a development of events, it is better to leave time to spare with the installation.
- Also, some manage to melt linoleum. This is possible when connecting the mounting wires.
- Do not forget and fix the strip of thermal film. To do this, use tape.
After all the work is completed, conduct testing and see how the design as a whole works. If there are any problems with it, then it is best to entrust the installation to professionals.
Leave Your Comment